| 6. This oval shape is a little bit tricky... Select the background layer and use the Magic Wand tool  with tolerance "100". Select the oval shape. Then add a new layer. Use the  tool to fill the upper left with black and the down left with white. Set the airbrush-pressure to about "4" and the brush-size to "100". Take it very careful! |
NOTE! Place this layer direct after Layer 1 since it only shall affect that layer. |
| 7. Now, time for the three little buttons at the top. Again, select the background layer and use the Magic Wand tool with tolerance "100". Hold down the shift-key to get all three. Create a new layer and fill the buttons with desired colour. Now, use the tool to make a gradient effect from upper left to down right. |
If you´re using green, as I did, I will recommend a darkgreen shade, and white in the right corner. Then apply the Inner bevel filter with the approx settings: width=3, smoothness=1, shadow depth=50. |
| 8. Now, let´s go down to the spheroid in the left.... Again, select the background layer and use the in the circle with tolerance "100". Create a new layer. Fill the selection with black. Use the Glass lens in KPT and then use the with white to add the 3-D feeling down right. Set the airbrush-pressure to about "2" and the brush-size to "50". |
 |
| 9. The two little guestbook buttons. Again, select the background layer and use the Magic Wand tool with tolerance "100". Hold down the shift-key to get both. Create a new layer and fill the buttons with desired colour. Now, use the tool to make a gradient effect from upper left to down right. Then apply the Inner bevel filter with the approx settings: width=3, smoothness=1, shadow depth=50. |
|
| If everything is right done, it should look somethig like this... But there is still a lot to do before it is all completed. Well..go to the next page and find out then.... |
 |